LAPLACE INSTRUMENTS PRODUCT LINE
Products by EMC Categories
Emissions
• Antennas
• EMC Emission Analyzers
• LISN
• Near Field Probes
• Pre-selector
• Reference Sources
• RF Sensors/Probes
• Test Cells
• Test Chambers
• Voltage Probe (PLIP)
Harmonic and Flicker
• AC2000A Harmonics & Flicker Analyzer
• AC1000 Clean Power Source
Immunity
• CDN’s
• Dips and Interrupts
• EFT & Burst
• ESD
• Power Amplifiers
• Sensors/Probes
• Surge
• Synthesizers
• Test Cells
• Test Chambers
Mains Filters
Product Software
RF Meters and Sensors
Systems
• Conducted Emissions
• Conducted RF immunity IEC1000-4-6
• Harmonic and Flicker
• Luminaire Test (EN55015)
• Non-RF Immunity IEC61000-4-4 IEC61000-4-5 IEC61000-4-11
• RF Emissions (CDN)
• RF Emissions (Cell/Chamber)
• RF Emissions (OATS)
• RF Immunity (Cell/Chamber) IEC61000-4-3
• Standards
• Sale! Radiated Emission Test System – Reduced!
RELIANT EMC PRODUCT LINES
MANUFACTURERS
Request a Quote / Contact Us!
LAPLACE 55025
Standard |
EN55025 |
Scope |
Vehicles, boats and other internal combustion engines. |
Type
|
RF emissions measurement for the protection of on-board receivers. |
The table below shows the test requirements and ancillary items. Common to all tests are an EMC analyser (SA1002 or SA3000), pre-selector (RF910), pre-amplifier (SA1020) and associated software (included with the EMC analyser).
EN 55025 Clause |
Item |
Type |
Freq. range |
Method |
Ancillaries |
5 |
Whole vehicle |
Radiated |
As specified |
On-board antenna |
Antenna matching unit |
0.5 -30 |
|||||
30 – 1000 |
¼ wave monopole |
||||
1000-2500 |
As recommended |
||||
Whole vehicle |
Appropriate bands. |
On-board antenna |
LISN (CISPR16) |
||
6 |
Components & modules |
Conducted |
0.15 – 108 |
||
0.15 – 245 |
Current probe |
Current probe |
|||
Radiated |
0.15- 30 |
Antenna+ ALSE |
|||
30- 2500 |
Antenna + ALSE |
||||
Annex F |
0.15 – 245 (limited by cell size) |
TEM cell |
TEM cell |
||
Annex G |
0.15 – 980 (limited by stripline design) |
Stripline |
Stripline |
Notes:
ALSE = Absorber Lined Screened Enclosure.
Limits applicable to each test are included in the EMCEngineer software issued with the Laplace EMC analysers
Clause 5:
Emissions received by antenna on same vehicle.
Antenna is the one normally fitted to the vehicle. If non fitted, use 1m monopole (band B) or loaded ¼ wave monopole (band C & D).
Antenna matching unit reqd: Input imp. >100K II <10pF , Output imp.: 50R
Additional tests when vehicle is in charging mode.
AC mains: LISN: 50uH/50R AMN CISPR16
DC cable: LISN: 5uH/50R HV-AN High voltage
Comms lines: AAN (Artificial Asymmetric Network)
Clause 6:
Components & modules:
Power via 5uH AN (annex E)
Conducted emissions, LISN 5uH/50R, CISPR25 0.15 – 108MHz (All detectors)
Conducted emissions, current probe, 0.15 – 245MHz (Pk and Ave)
Radiated emissions, 1m monopole, 0.15 – 30MHz in ALSE
Radiated emissions, broadband antenna(s), 30 – 2500MHz in ALSE
Annex E:
5uH LISN i/p C = 1uF, 0/p C = 0.1uF, shunt R = 1K (CISPR25)
5uH HV AN i/p C = 0.1uF, o/p C = 0.1uF, shunt = 1K. Additional discharge R = 1M
50uH/50R CISPR16
AAN for comms lines: CDN (to give 150R impedance) For matching only.