Schlöder CDG 6000-75-DC_400 and CDG 6000-75_400 Conducted disturbance test generators acc. to IEC / EN 61000-4-6:2014 ISO 11452-4 (BCI)

• Integrated Direct Coupling at CDG 6000-75-DC_400 or without Direct Coupling at CDG 6000-75_400
• 100 kHz – 400 MHz
• 75 W

The test generator generates interferences as defined in IEC / EN 61000-4-6 – Immunity to conducted disturbances, induced by radio-frequency fields. The standard describes a test setup in which these high-frequency interferences can be influenced on a EUT without a complicated structure with antennas, field instrumentation and shielded rooms. By using coupling networks and coupling clamp’s sine waves are induced directly into power and signal lines. The test object retains its original place in the device structure, so that the system can be tested in its overall function.

Tests according to ISO 11452-4 (BCI tests) are also possible.

Overview:

• Computer-based system (USB).

• Self-calibration of the test system (generator and CDNs)

• RF-generator, amplifier and RF-voltmeter may as well be used as stand-alone devices

• Connections: EUT “Fail”, EUT monitoring by external multimeter, e.g. DUT signal

• Calibration of coupling / decoupling devices and EM clamp is performed automatically

• Extensive accessory like attenuators, calibration kits, etc. available

• Directional Coupler ( DC ) at model CDG 6000-75_DC_400 A directional coupler is used to measure and control the forward power of the amplifier – see the standard IEC / EN 61000-4-6, 2014. The quality of the built-in amplifier allows control of the level data through the system – see chapter 6.4 in the standard with respect of two methods. That means that a built-in directional coupler is in our test system not (necessarily) required. However, the control on the forward power during a test is the preferred method. An external directional coupler can also be connected or a CDG 6000 without DC can be retrofitted with a direct coupling.

 Schlöder CDG 6000-75-DC_400 and CDG 6000-75_400 Conducted Disturbance Test Generator Data Sheet

EN 61000-4-6 Injection Clamps

• Schlöder CDN EMCL 20 EM Clamp Data Sheet

• Schlöder CDN EMCL-35 Current Injection Clamp for RF Conducted Immunity Testing Data Sheet

Accessories

• Coupling Networks – 3 Phase

• SFT 415 Capacitive Coupling Clamp

• SFT 415 – CS: Calibration Set for CCC

• SFT 450-1 (50 Ohm) and SFT 450-2 (1000 Ohm) Attenuators

• SFT 470 Probe Set – Magnetic Field

• SESD 30 S 100 ESD-Soft 6 ESD Remote Control Software